NedMag B.V.
- Commissioning expected date
The technique reduces emissions of solid substances of very high concern (SVHCs), such as lead, cadmium and arsenic, from kiln flue gases by combining hot, dry and cold, wet gas streams and filtering them using PTFE bag filters with hydrated lime precoating. Operating at full scale since December 2024, it achieves over 95% reduction in solid SVHC emissions.
In the shaft kiln at around 2000 °C, substances of very high concern (SVHC’s), notably lead, cadmium and arsenic, evaporate and bind to very fine dust particles. The shaft kiln has 2 flue gas streams, one from the top and one from the bottom. The emission reduction technique from the top stream (burned natural gas) consists of a cyclone and a wet scrubber. The waste gas coming from the wet scrubber contains about 2 mg/Nm3 SVHC and is relatively cold (65°C) and wet (100% RH). The bottom stream (an air flow for cooling the product) passes through a cooler and the emission reduction technique is a cyclone. The flue gas coming from the cyclone contains no SVHC and is hot (typically 300°C) and dry. Based on national legislation the permitting authority requested to reduce the emission of total SVHC’s below 0.1 mg/Nm3. This means that the emission has to be reduced with at least 95%. However, the low temperature and high relative humidity means that a standard filter technique could not be implemented. Therefore, it was decided to use the hot dry flue gas from the bottom stream to increase the temperature and make it possible to implement a bag filter. In order to reach the required emission limits the filter surface was approximately doubled compared to standard filters. The filter bags are made of PTFE (polytetrafluorethene). In order to Improve SVHC capture, before starting operation a precoating of hydrated lime is applied to the filter. To prevent caking the precoating is removed and reapplied if a (maintenance) stop lasts at least two days. In order to prevent corrosion by acid condensates the temperature of the mixed streams should not be too low. To achieve a higher temperature, flow control is applied to the bottom stream to increase its temperature to about 350 °C.
The filter was fully paid for by Nedmag, no outside funding or subsidies were provided. The project has started mid 2023 by defining the reduction targets and selecting a suitable supplier.
The technique also contributes to additional abatement of acid gases. Energy efficiency is enhanced by using waste heat to increase the temperature of the cold, wet stream. While energy consumption and waste generation slightly increase, the environmental benefits are substantial. The technique’s scalability depends on flue gas humidity and temperature conditions, with potential application across similar industrial setups.
The main barrier to implementation were permitting issues. Legally we are not allowed to mix two waste gas flows when it means that it will result in a dilution of one of the flows. And so be easier to comply with permit or legal requirements. However, in this case mixing of the flows was necessary to achieve the necessary temperature and relative humidity to apply the filter. Or the gas flow had to be reheated before, making it more energy consuming.
Associated main production process(es) and product(s): Dead Burned Magnesia (DBM) ; Caustic Calcined Magnesia (CCM)
As compared to: Standard filters
Legend
Other substances are the Substances of Very High Concerns such as Arsenic or hexavalent chromium
Industrial symbiosis resource flow:
CAPEX 2-3 M€ for an installation for a maximum combined flow of 30,000 Nm3/h.